This was an issue in previous versions of ACA SAG10 and will be addressed in version 4.0.
The “wind only” selection on the ADSS parameters entry screen has “ice only” choices.
This was an error in the previous version of SAG10 and will be corrected in the next version.
When you change the font from the Sag & Tension Data screen, the does not change.
To see the change, you have to return and run the calculations again.
Some of the project files saved in prior versions of ACA will not load.
Southwire has attempted to maintain compatibility with prior saved project files, but prior versions of SAG10 did not always save the project information correctly. In fact, sometimes they would not even load in the ACA versions. You may be requested to re-enter data that SAG10 does not recognize, or you may have to re-build your project in Southwire SAG10 to have the data store correctly.
When I set my monitor to a high resolution, like 1920x1200, some of the screens look different.
The software may look different based on your monitor resolution. If you are having problems reading screens, please set your monitor to a lower resolution.
What happened to Vibrec?
The Vibrec vibration analysis software was kept by ACA so is not longer a feature in SAG10. Please visit their website to obtain a free copy of the Vibrec software.
